Sportline Fitness Electronics WV3480IS01SPTRA User Manual

10  
1
11  
12  
13  
14  
15  
16  
GUARANTEE CERTIFICATE  
trousers as close to the crease line as possible.  
2. The pedometer must always be in a horizontal position,  
parallel to the ground. Do not attach it at an angle or  
sideways as false readings will occur.  
repeated as frequently as you like.  
Press Button B (+START/STOP) to stop the timer.  
Press Button D (SET/RESET) to clear the recorded time.  
values of 30 in/75cm):  
1. Decide first whether you want your pedometer’s Distance  
Mode to operate in Miles or Kilometers.  
NOTE: The default settings are 30-in/75 cm. If you need to  
set your stride length lower than the default settings you will  
need to advance through the maximum setting (96 in/240  
cm) until the pedometer registers the minimum settings of 12  
in/30 cm and advance the stride length from their until you  
reach your desired setting.  
of 21.8 MIL/H or 34.56 KM/H  
REPLACEMENT  
For purchases made in the U.S.  
TO MEASURE STRIDE LENGTH:  
This product has been carefully designed, manufactured  
and packaged. If any parts are missing or damaged,  
please contact us at the address above and we will replace  
the unit at no charge. (Guarantee does not cover crystal or  
battery.)  
If at any time within one (1) year from the purchase date of  
this product, it fails to perform properly because of defects in  
material or manufacturing, return it prepaid to:  
You will need to input your stride length in order to get  
accurate readings of your walking and/or running progress.  
2. Determine if the Distance Mode is currently set to MIL or  
KM. If already set to your desired measurement, please  
skip to #4.  
3. If you need to change from MIL to KM or vice versa while  
in Distance Mode press and hold Button D (SET/RESET)  
for about 5 seconds and you will see the display change.  
4. Press Button A (ALT/ALARM) to get to Distance Mode  
(MIL or KM will show at the bottom of the display).  
5. Press Button C (WALK/RUN–SPLIT) to go to the WALK pace.  
6. Press Button D (SET/RESET)  
7. Press Button B (+START/STOP) to enter your stride  
length. Each press of the button will increase the length  
by 1 inch or 1 centimeter depending on the measurement  
system you are using. If you hold Button B  
DOUBLE TIME MEASUREMENT:  
Press Button B (+START/STOP) to start the measurements  
of two events simultaneously.  
Press Button C (WALK/RUN – SPLIT) to measure the time  
of the first event. The flashing word SPLIT indicates that the  
measurement of the second event is functioning internally.  
Press Button B(+START/STOP) to stop the measurement of  
the second event. The word SPLIT stops flashing.  
Press Button C (WALK/RUN – SPLIT) to display the time of  
the second event.  
10  
8
6
4
You can measure your stride length b  
2
y doing t  
0
he following:  
TO REPLACE BATTERY:  
BATTERY REPLACEMENT  
1. The battery hatch is on the front side of your pedometer.  
Open the battery door with a coin to access the battery.  
2. Replace with type AG13, LR44 or equivalent battery  
when display dims.  
EB SPORT GROUP, 585 Oak Ridge Road, Hazleton, PA 18202  
9
7
5
3
1
Complete this Guarantee Certicate and enclose it  
(or a copy of it) with the product.  
(PLEASE PRINT CLEARLY)  
Step Distance  
Ideal Distance  
TO ENTER STRIDE LENGTH IN RUN SETTING (Range is from  
12 in 30 cm to 96 in/240cm with default values of 42-in/ 100cm):  
Follow instructions as above for setting your stride length in Walk  
Setting. The only difference will be in #5 you will press Button C  
(WALK/RUN – SPLIT) until RUN appears on the display.  
For purchases made in the UK:  
Should you experience problems with this item, please  
return it to the point of purchase. This will not affect your  
statutory rights. Alternatively return it to the address shown  
below for a repair/replacement: StarCase (UK) Ltd,  
Berkeley Business Park, Wainwright Road, Worcester  
1. Walk 10 steps.  
2. Measure the distance that you’ve walked either from  
heel-to-heel or toe-to-toe.  
3. Divide by the distance covered by the number of steps  
take to arrive at your Stride Length.  
4. Example: measured distance covered 360 inches,  
number of steps taken was 10 so divide 360 by 10 to  
get 36. 36 inches is your stride length.  
3. When replacing battery door, be sure to place the longer  
tabs at the top into their respective compartment slots  
first in order to prevent breakage.  
NAME  
TEL  
347  
TO START YOUR EXERCISE:  
4. Reset the pedometer and re-enter the STRIDE length.  
WR4 9FA  
Please note: Before using your  
Walk-Run Pedometer  
ADDRESS  
Press Button D (SET/RESET) for about 1 second. All  
exercise data readings will be reset to zero. When you  
begin exercising will flash and the exercise data will show.  
When you press Button A (ALT/ALARM) you can see the  
step counter, distance traveled, speed and exercise time  
rotated on the display with each press.  
pedometer, remove battery  
insulation strip. (Insulation strip  
designed to preserve battery power)  
Press Button D (SET/RESET) to clear the recorded time for  
both values.  
CAUTION – Battery Safety Information  
• Non-rechargeable batteries are not to be recharged  
• Rechargeable batteries must be removed before recharging  
• Rechargeable batteries only to be recharged under adult  
supervision  
• Do not mix alkaline, standard (carbon-zinc), or rechargeable  
(nickel-cadmium) batteries  
• Do not mix old and new batteries  
• Exhausted batteries to be removed  
• Do not dispose of batteries in fire; batteries may explode  
or leak  
• Do not dispose of product in fire; batteries may explode  
or leak  
PEDOMETER MODE:  
(+START/STOP), the numbers will advance continuously  
until you release it. Release it when the display reaches  
the stride length you want to set it to. The stride length  
will flash for a few seconds. When it stops flashing the  
stride length will be set in memory.  
CITY  
The pedometer mode is symbolized by . Your pedometer  
can be set to be used at either a walking or running pace  
and will cover the following:  
STATE  
ZIP  
Important: Please remember that the length of your stride  
while walking is different than the length of your stride while  
running. You will need to measure your stride separately for  
both walking and running so that you can use your  
pedometer in the appropriate pace setting.  
Sportline® and Walking Advantage by Sportline™ are trademarks of SPORTLINE,  
a division of EB Sport Group, Yonkers, NY 10701  
STORE PURCHASED FROM  
DATE OF PURCHASE  
PROBLEM WITH PRODUCT  
HOW TO WEAR YOUR PEDOMETER:  
1. Exercise Time (Up to 9 hours, 59 minutes and 59  
seconds).  
2. Number of Steps (Up to 99999 steps)  
3. Distance Covered (Up to 999.00 miles or kilometers)  
4. Speed updated every 6 seconds (to a maximum reading  
PURCHASE PRICE  
Distributed in the UK by StarCase (UK) Ltd., Worcester, WR4 9FA  
All Rights Reserved. ©2008  
Or pressing (ALT/ALARM) to back to Distance Mode  
8. You can go back to the stride length default setting  
(30-in/75 cm in Walk Mode or 42-in/100cm in Run Mode)  
by pressing Button D (SET/RESET).  
WV3480IS01SPTRA  
TO ENTER STRIDE LENGTH WHILE IN WALK SETTING  
(Range is from 12 in 30 cm to 96 in/240cm with default  
1. Clip the unit to your belt or the top of your shorts or  
#3480  
© 2008 EB Sport Group  
To adjust the minutes and hours when setting the alarm  
time in Alarm Mode.  
DISPLAY OPTIONS:  
WALK – STEP OR RUN – STEP: Counts steps whether  
walking for running  
– Indicates that data is being recorded  
CLOCK MODE:  
This mode will be symbolized by A or P in 12 hour format or  
24hr in 24 hour format.  
Press Button D (SET/RESET) once more to end setting.  
TURNING THE ALARM ON/OFF:  
BUTTON FUNCTIONS:  
IMPORTANT: READ THROUGH ALL INSTRUCTIONS  
BFORE BEGINNING TO USE YOUR PEDOMETER  
B
WALK – KM or RUN – KM – Pedometer is measuring  
distance in kilometerWsALK RUN  
Indicates the alarm is on  
A
C
Press Button A (ALT/ALARM) to turn the alarm on/off in all  
To adjust your stride length while in Distance Mode  
modes except the pedometer mode. A  
appears when  
P
WALK  
STEP  
the alarm is on and there will be a ‘beep’ sound when  
pressing any key in every mode once the  
alarm was set  
Button C – WALK/RUN – SPLIT – You would use this  
button to:  
• Adjust your unit to a walking or running pace  
• In stopwatch mode it enables you to split time an event  
BEFORE USING YOUR PEDOMETER YOU WILL NEED  
TO DO THE FOLLOWING:  
1. Remove the battery insulator tab from the battery  
compartment to turn your pedometer on.  
2. Remove the plastic static label from the display screen  
to read your display.  
SETTING TIME:  
KM  
Press Button D (SET/RESET) for 2 seconds while in clock  
Mode and the minute digits will flash. The second digits  
clear to zero at the same time.  
Indicates you are in stop watch mode  
D
E
WALK – MIL/H or RUN – MIL/H – Pedometer is calculating  
STOPWATCH MODE:  
Press Button B (+START/STOP) to adjust the minutes  
Press Button D (SET/RESET) and the hour digits flash  
Press Button B (+START/STOP) to adjust the hours  
To switch between the 12/24 hour system press Button E  
(MODE/SYSTEM)  
your speed in miles  
In this mode the unit can be used as a stopwatch. It can  
time up activity up to 9 hours, 59 minutes and 59 seconds  
up to one hundredth of a second.  
CLOCK – 12 hour format will show A or P  
WALK RUN  
Button D – SET/RESET – This button serves several  
functions:  
• Resets all data back to zero (except the Clock and Alarm  
Time)  
• In Clock Mode enables you to set the time  
• In Alarm Mode enables you to set the alarm  
• Resets stride setting back to the default (30-in/75 cm for  
Walk mode or 42- in/100cm for Run mode)  
The display will show all segments for 2 seconds and all  
data is cleared. The unit will then enter into Clock Mode.  
MIL/H  
P
NORMAL STOPWATCH TIME MODE:  
SPLIT – If this appears at the top of the display while in  
stopwatch mode it indicates that you are using the split  
Press Button D (SET/RESET) once more to end setting.  
Press Button B (+START/STOP) to start the stopwatch timer.  
Press Button B (+START/STOP) again to stop the stopwatch  
timer.  
This is a multifunctional unit with several features to  
enhance your exercise program. Features are:  
WALK – KM/H or RUN – KM/H – Pedometer is calculating  
your speed in kilomeWteALrKsRUN  
timing feature. If SPLIT is flashing, it is internally timing the  
24 hours format will show 24hr  
SPLIT  
ALARM MODE:  
split time.  
The alarm mode is symbolized by the word ALARM to set it  
Press Button D (SET/RESET) to clear the recorded time.  
24 hr  
and the  
when the alarm is in the On position. When  
Counts Steps (counts from 0 to 99999)  
Measures Distance in Miles or Kilometers (from 0.00 to  
999.99)  
Clock with Alarm (12 or 24 hour format)  
Stopwatch with Split Time Function (times activity up to 9  
hours 59 minutes and 59 Seconds)  
Button E - MODE – SYSTEM – This button does the  
following:  
• Switches time from 12 hour to 24 hour format and vice  
versa  
• Advances you through Mode Selections from Clock,  
Alarm, Stopwatch and Step  
Button A- ALT-ALARM – This button is used to  
• Turn clock alarm on and off  
• Change modes from Step to Distance to Speed  
the alarm time is reached it will beep for approximately 20  
seconds.  
SPLIT TIME MEASUREMENT:  
KM/H  
Press Button B (+START/STOP) to start the stopwatch timer.  
Press Button C (WALK/RUN – SPLIT) to measure the split  
time. The ashing SPLIT indicates that the timer is working  
internally although the numbers may remain the same.  
Press the C (WALK/RUN – SPLIT) key to release the split  
value. SPLIT disappears and the normal time measurement  
appears again. The split time measurement can be  
WALK – MIL or RUN – MIL – Pedometer is measuring  
The word ALARM will indicate the time the alarm  
is set to  
WALK  
SETTING ALARM TIME:  
Press Button D (SET/RESET) for 2 seconds while in Alarm  
Mode and the minute digits will flash.  
Press Button B (+START/STOP) to adjust minutes  
Press Button D (SET/RESET) and the hour digits flash  
Press Button B (+START/STOP) to adjust the hours  
WALK RUN  
distance in miles  
Button B - + START/STOP -- You would use this button for  
the following:  
To adjust the minutes and hours when setting the clock  
in Clock Mode.  
– Pedometer is recording your  
A
Calculates Speed (Up to 1/1000 of a mile up to a maximum  
speed of 21.8 MIL/H or 34.56 KM/H per hour)  
ALARM  
activity time  
MIL  
2
3
4
5
6
7
8
9
WV3480IS01SPTRA  
07/15/08  
 

Sharp PDAs Smartphones EL 6053S User Manual
Shindaiwa Trimmer T261 EVC User Manual
Sigma Computer Monitor SQM 160 User Manual
Silicon Image Network Card SSD P08GI 3521 User Manual
SMSC Network Card LAN1198 User Manual
Soehnle Scale FT 5 User Manual
Sony Ericsson Projector VPL PX30 User Manual
Sony Stereo Amplifier XM 5046 3546 User Manual
Sony TV VCR Combo KV V1430K User Manual
Sylvania Flat Panel Television LC370SS8 User Manual